Turn Your Home PC into a Complete Recording Studio
Want to turn your home PC into a complete Recording studio to
record, edit, and play back digital audio files, this article,
describes how and what you need do it.
Do
you possess a multimedia PC with a sound card and speaker? All you
require is an inexpensive recording and editing software to your PC,
with this you can produce high-quality, effective voice and music
recordings. The basic prerequisite to get a level of recording are a
PC, Quiet recording space, Microphone, Speakers and headphones,
recording software.
Our aim is to record a clear, close voice
track, so we need a Quiet recording space, which means keeping noise
and the sound of the room out of the reach till the finished recording
meets all our needs. Professional’s records in closet specially
designed to keep noises out and make their voice sound good.
To
get your voice or recordings into the computer, you need a microphone.
Don't relay on the dull one that you got with your computer. Choose
high-quality, inexpensive Microphone that sounds far better.
Microphones are available from music or audio equipment suppliers.
There are microphones for the basic voice work. Choose the microphone
that best suits for female voice and male voice.
Choosing of
computer speakers tends to be given importance because it impacts on
getting quality output of recording. Computer speakers are adequate for
recording, editing, and finishing basic recordings, but empower some
decent powered speakers to get better quality output.
The net
result you get in recording apparently depends on the Recording
software that is being used. Choose recording software equipped with
all editing features such as with best bit rate, creating special
effects adding music and/or sound effects and the software should
present your recordings in the formats you desire. The music software
that best suits for professionals as well as beginners are FlexiMusic’s
FlexiMusic Wave Editor, a software for recording and editing.
Part 1: Getting Started Fasten
up your equipment by plugging your microphone into your sound card's
microphone. Be careful in this, since there are three plugs there,
choose the one that Is written as “Mic”. Now launch the software that
controls the sound card’s recording source (for this you can use the
“Recording source” command in FlexiMusic Wave Editor). Then select your
recording source (Mic) and adjust its volume at 100%.
Start
your recording program (say FlexiMusic Wave Editor), choose stereo, bit
rates of 16 bits, 44kHz of sampling rate and at CD-quality. Start the
recording command. Adjust the volume so that Digital level meters shows
3/4th volume, if it exceeds it will sound horribly distorted.
To
improve the sound of your recordings, get closer to the mic. The
farther away you are from it, the more you pick up the room noise
around you. Get closer and your voice is closer. Advantage of getting
closer to microphone may bring out the lower frequencies in your voice
and can make you sound more powerful. Obviously, locate your recording
area away from noisy equipment. Some precautionary things that are to
be taken care are, put a little distance between the mic and the noise
source. Avoid salty foods immediately before your recording session.
Have some water nearby and apply a little lip balm. These will keep
your mouth and lips lubricated. When you're ready to record, speak
clearly and slowly. You can always tense up your recording while
editing. If an error occurs go back to the nearest sentence start and
continue on again.
Part 2: Editing the recordings “As haste
makes waste”, don’t fix everything in one take. Record as many times as
needed and assemble the best parts into the final recording. Calculate
whether the recording done has everything that you desired. If not,
don’t pamper, go back and re-record the bits you need, listen again,
and repeat the process until you obtain the desired. You see a
two-dimensional representation of the words as sound waveforms. You can
hear the words as you play them. Cut, copy, paste is all the techniques
you apply when editing sound.
Early to begin editing, make sure
to turn off the mic, disconnect the headphones, and switch off
speakers. Delete the unnecessary things that interrupt the output of
the recording. Eliminate the junk and move further improving your
performance. Never give up to until you get the best result of
recording. Do carry out as many takes as needed, find the best takes
out of it and build your final version from them.
Make sure of
any changes you have done during editing. Analyze, if you can make it
better. Check whether the volume is consistent? Are there any noises,
background sounds, or other unwanted junk parts that which can be
eliminated or reduce?
After editing the voice, to make it
efficient better you can add music or sound effects to enhance the
final version. You add the back ground effect using the same software
FlexiMusic Wave Editor, open the music file in audio software, select,
and copy it to the clipboard. If needed trim the music to match the
length of your voice recording, then, place the cursor at the start of
your voice recording, and select Edit > Paste Mix. Make sure that
you can hear your voice recording clearly with the music playing in the
background.
Now make the best use of your audio software's to
maximize the recording's volume. Next, choose a format in which you
want your recordings to be such as, Mp3, WMA, Snd, Raw, and Au. Select
the recording which is in the waveform and save the file to the audio
format of your choice. Using mp3 or WMA files is useful to save space
on your hard drive while retaining reasonably good quality and for
transmitting your work over the Internet.
Finally you have done!
You can play back the file in FlexiMusic Wave Editor, or with any audio
program, such as Windows Media Player or Winamp, and transliterate the
recording.
About the Author: The author is a passionate internet
user. He is fond of all kinds of music, more enthusiastic in learning
and programming music related software. To know about the author please
visit http://www.fleximusic.com/ http://www.fleximusic.com/waveditor/overview.htm
|

|